From inside-the-Beltline bungalows in Hayes Barton to 1990s North Raleigh subdivisions hitting replacement age, we right-size and install heat pumps and HVAC systems built for hot, humid Piedmont summers.
We run a true Manual-J load calculation for your home’s square footage, insulation, and window load — oversized units short-cycle and leave Piedmont humidity behind.
Indoor and outdoor units are paired to a verified AHRI match so you get the rated efficiency and a clean warranty — not a mismatched changeout.
Carrier, Trane, Lennox, Rheem, Goodman, Mitsubishi mini-splits and more — we recommend the right fit for your house and budget, not one brand we’re tied to.
We haul out the aged-out equipment, recover refrigerant to EPA spec, and leave the closet, attic, or pad ready for the new install.
Raleigh’s housing stock runs the full spectrum, and so do its HVAC needs. The 1910s–40s Craftsman and bungalow homes around Five Points and Hayes Barton were never built for central air, which makes ductless mini-splits and high-velocity systems strong retrofit candidates. Meanwhile, the 1980s–2000s subdivisions across North Raleigh and Brier Creek are now hitting the age where original systems give out — and a planned replacement beats an August breakdown every time.
If your system is under about 10 years old and the repair is minor, fixing it usually makes sense. Once a unit is 12–15 years old, still runs on R-22 refrigerant, or needs a compressor or coil, replacement is almost always the smarter spend. We give you both numbers honestly — the repair quote and the replacement quote — and let you decide with real information, not pressure.
Because Raleigh summers are hot and humid and winters stay mild, heat pumps dominate here, and getting the size right matters more than chasing the biggest unit. An oversized system cools the air fast but never runs long enough to pull moisture out, leaving your home clammy. We size for both temperature and humidity, and we’ll talk through variable-speed and dehumidification options where they earn their keep.
Triangle Backflow, Heating & Air is based in Chapel Hill and serves Raleigh and the wider Triangle with a local, certified, and fully insured team. Every install is documented, AHRI-matched, and backed by clear warranty paperwork we handle for you.
Inside the Beltline, many Hayes Barton and Five Points homes have no ductwork or undersized chases that make a conventional changeout awkward. For those, we often spec ductless mini-splits or compact high-velocity air handlers that condition every room without tearing up plaster walls — a far better fit for a 1920s Craftsman than forcing in oversized trunk lines.
On the other end, North Raleigh and North Hills are full of larger two-story homes and downtown infill where a single system struggles to balance floors. We zone these properly, sometimes with dual systems or zoning dampers, so the upstairs bedrooms and the main living level both stay comfortable through a Piedmont July.
We measure the house, check ductwork and electrical, and run the load calc — no eyeballing off the old unit’s label.
You get repair-vs-replace numbers and matched system choices across major brands, with the efficiency and price spelled out.
We remove the old equipment, install the AHRI-matched system, and set the line set, pad, and connections to spec.
We charge, balance airflow, confirm dehumidification, and register the warranty before we leave.
From inside-the-Beltline to North Raleigh and Brier Creek, we install and replace HVAC systems across Wake County and the wider Triangle.
Certified · paperwork handled · flat-rate pricing.